[Bob Deskin]

When you run it as source, are you executing each request separately? 
Versus combining the requests into one compiled run.

Other than that, I'd have to see the code. I suppose it's possible that 
some SET has gotten lost when you compile. 

What version is this? Is it IMAGE or KSAM? Can you isolate the file that 
this happens with?

Bob



From:
lorcan-computers at fsmail.net
To:
powerhouse <powerh-l at lists.sowder.com>
Date:
2009-11-12 02:36 AM
Subject:

Sent by:
powerh-l-bounces+bob.deskin=ca.ibm.com at lists.sowder.com



Hi Guys,
Hoping you can help me.
I have a piece of compiled QTP which run's within a job on a HP3000 and it 
errors with a 'Record has changed since you found it' error. I have run 
the QTP outside of the job and get the same error, but if I run the 
uncompiled code it completes without a problem. I have recompiled the 
source to ensure that the version in the job was compiled using the same 
source ( I hope this makes sense and doesn't get confusing) and reran 
getting the same error. So basically, compiled version errors, uncompiled 
completes successfully
Any ideas ?
Cheers
 
Ron

-- 
= = = = = = = = = = = = = = = = = = = = = = = = = = = =
Mailing list: powerh-l at lists.sowder.com
Subscribe: 'subscribe' in message body to 
powerh-l-request at lists.sowder.com
Unsubscribe: 'unsubscribe &lt;password&gt;' in message body to 
powerh-l-request at lists.sowder.com
http://lists.sowder.com/mailman/listinfo/powerh-l
This list is closed, thus to post to the list you must be a subscriber.
Add 'site:lists.sowder.com powerh-l' to your search terms to search the 
list archive at Google.