Refresh records

[Guy Werry]

If I'm understanding you correctly, you don't object to having the Quick
screen have to re-read the data base, you want this to be transparent - not
having to re-enter the parameters.  

If you had the selection fields declared as temporary variables, with RESET
AT MODE or RESET AT STARTUP, then you could probably either do a PUSH of the
FIND command, or have a designer file access.  Note that I haven't tested
this, this is only to give a path that might work.

G.L. (Guy) Werry 
Senior Systems Analyst
Hudson Bay Mining & Smelting
Ph:  204-687-2374
Fax: 204-687-2771
guy.werry@hbms.ca

 -----Original Message-----
From: 	Markus Grossrieder [mailto:markus.grossrieder@alba-systems.com] 
Sent:	May 3, 2002 10:02 AM
To:	PowerHouse List (E-mail)
Subject:	Re: Refresh records

Thanks Bob and  Joe,

ok, I'll try it the other way round:
After having found my record by entering 3 values and doing an update in a
QTP,
I'm looking for a way to refresh the data WITHOUT doing my FIND again. I
don't
mind to enter F or to start another designer procedure, but I don't want to
enter the same search values again, just ... a refresh of the data in
Quick's
buffer and display them (like, say, in Access, Ctrl-F9 ... ok, it's a bad
example, but you get the picture).
I don't know for example if I can do something with the MISSING and
DISPLAYED
parameters in the FOR construct. If it's not possible: it would be a nice
feature (Bob, Conrad, Carol, Christina, Allison et. all.)

Kind regards,
Markus

----- Original Message -----
From: "Markus Grossrieder" <markus.grossrieder@alba-systems.com>
To: "PowerHouse List (E-mail)" <powerh-l@lists.swau.edu>
Sent: Thursday, May 02, 2002 5:55 PM
Subject: Refresh records


> Hi list,
>
> is there a way to refresh records shown in a Quick screen, after they are
> updated by an other program (say, a QTP), without doing a find again ?
>
> (Powerhouse  7.10.G3, OpenVMS V7.2-1)
>
> TIA, regards,
>
> Markus
>


= = = = = = = = = = = = = = = = = = = = = = = = = = = =
Mailing list: powerh-l@lists.swau.edu
Subscribe: "subscribe" in message body to powerh-l-request@lists.swau.edu
Unsubscribe: "unsubscribe" in message body to
powerh-l-request@lists.swau.edu
http://lists.swau.edu/mailman/listinfo/powerh-l
This list is closed, thus to post to the list you must be a subscriber.