Time Stamping to the second

[Dave Knispel]

The way we handled this was by modifying the QUIZ and QTP command files to
add a SHOWTIME at the start of the command file.  You could add SHOWVAR
HPDATETIME if you want to see seconds (and below).

David Knispel
dave.knispel@frequencymarketing.com
Phone: 513-248-5029
Fax: 513-248-2672



-----Original Message-----
From: powerh-l-admin@cube.swau.edu
[mailto:powerh-l-admin@cube.swau.edu]On Behalf Of Steve T Wright
Sent: Friday, March 22, 2002 2:28 PM
To: powerh-l@lists.swau.edu
Subject: Time Stamping to the second


Hey Y'all,

I have the need to timestamp the begining and ending of a QUIZ program for
performance benchmarking between two HP3000s. The systime / sysdate
commands do not provide minutes, much less seconds.

Any ideas... I am not opposed to using commands within MPEX before and
after the program within a job stream.

Environment:  HP3000 987sx   MPE  (MPEX is installed)..  Powerhouse 8.19 D7

Thanks for any ideas.... then you can just go home... tell your boss I said
it was OK....

....Steve Wright


= = = = = = = = = = = = = = = = = = = = = = = = = = = =
Mailing list: powerh-l@lists.swau.edu
Subscribe: "subscribe" in message body to powerh-l-request@lists.swau.edu
Unsubscribe: "unsubscribe" in message body to
powerh-l-request@lists.swau.edu
http://lists.swau.edu/mailman/listinfo/powerh-l
This list is closed, thus to post to the list you must be a subscriber.