Impromptu - Changing the catalog information

[Blue]

Wes

This is a common issue with Impromtpu.  Did you change the database in the
Data window of the report to point to the new database connection?  And did
you then save the report with this new information before running it?

Your might find better expertise in another forum than the PowerHouse list.

Regards,
Blue

> -----Original Message-----
> From: powerh-l-admin@cube.swau.edu
> [mailto:powerh-l-admin@cube.swau.edu]On Behalf Of
> Wesley_Patton@ci.sf.ca.us
> Sent: Tuesday, September 04, 2001 2:32 PM
> To: powerh-l@lists.swau.edu
> Subject: Impromptu - Changing the catalog information
>
>
>
>
> I have an installation on my WIN95 PC using Impromptu 4.0 2009.
> We went from a
> seemingly intelligent name of GIS-OLD and have changed to another
> seemingly
> intelligent name of GIS-ADHOC.  These are both running against
> the same data
> base, an ACCESS MDB.  After changeing everything over, I try to
> run a report and
> I get an error message:
>
>  **** ERROR ****
> Data item [\Wtw-plan] is invalid because
> [[GIS-OLD.O:\Bulletins\DATA\gis1.W2W.wtw-plan]] could not be found.
>
>  **** ERROR ****
> Data item [\Wtw-start-dt] is invalid because
> [[GIS-OLD.O:\Bulletins\DATA\gis1.W2W.Wtw-start-dt]] could not be found.
>
>  **** ERROR ****
> Data item [\Wtw-exp-end-dt] is invalid because
> [[GIS-OLD.O:\Bulletins\DATA\gis1.W2W.Wtw-exp-end-dt]] could not be found.
>
>
> I have looked throughout the Impromptu menus there doesn't seem
> to be any place
> where this is changable.
>
> Does anyone know about this issue?  Can anyone shed some light on
> this one?
>
> Thank you in advance.
>
> Wes Patton
>
>
>
> = = = = = = = = = = = = = = = = = = = = = = = = = = = =
> Mailing list: powerh-l@lists.swau.edu
> Subscribe: "subscribe" in message body to powerh-l-request@lists.swau.edu
> Unsubscribe: "unsubscribe" in message body to
> powerh-l-request@lists.swau.edu
> http://lists.swau.edu/mailman/listinfo/powerh-l
> This list is closed, thus to post to the list you must be a subscriber.
>