Running Quick in Batch

[Rich `Lego-Man' Jesse - 7633]

Carol Kaffenberger posted:

CK> I want to run Quick in batch mode to edit some data.
CK> (MPE/ix 5.5 PP7,PH819C5).
CK> When I run it interactively, it works fine.  But when I run
CK> it from a job, I get the following:
CK> 
CK>  Q U I C K   (PowerHouse  8.19.C5)
CK>  No port information found.
CK>  Terminal type=
CK>  Terminal type=
CK>  *E* No valid terminal type was specified.
CK>  QUICK session completed.
CK>  END OF PROGRAM
CK> 
CK> I tried to run it as:
CK> 
CK> :QUICK "AUTO=CAROLQQQ.CAROL"
CK> 
CK> and as:
CK> 
CK> :FILE QKGO=BTQKGO.CAROL    (with the first screen =
CK> CAROLQQQ.CAROL)
CK> :QUICK
CK> 
CK> but I get the same results when I run it from a job.  What
CK> am I missing?  Can I set the terminal type to some value?

Perhaps a "term=vt100" parameter in your QUICK statement would work?  You may
need to change "vt100" to a different terminal type for MPE, but it's worked
for me on VMS and HPUX.

HTH!  Good luck!  :)

Rich Jesse                              System/Database Administrator
rjesse@qtiworld.com                     Quad/Tech International, Sussex, WI USA
= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =
Subscribe: "subscribe powerh-l" in message body to majordomo@lists.swau.edu
Unsubscribe: "unsubscribe powerh-l" in message to majordomo@lists.swau.edu
This list is closed, thus to post to the list, you must be a subscriber.